Máy cắt siêu âm công nghiệp Honda Industrial ultrasonic cutter, model: USW-335Ti

Sản phầm nổi bật

Trusco

Tsubaki

OTSUKA

Ebara

Atago

Tin tức mới nhất

Vì sao khách hàng chọn mua máy nén khí Nhật bãi ?Tại sao máy nén khí trục vít Buma tạo được lòng tin với người tiêu dùng?Một vài sự cố sử dụng biến tần trong máy nén khí Lựa chọn máy nén khí Nhật Bản

Máy cắt siêu âm công nghiệp Honda Industrial ultrasonic cutter, model: USW-335Ti

Mã sản phẩm: USW-335Ti

Tình trạng:

Máy cắt siêu âm công nghiệp Honda Industrial ultrasonic cutter, model: USW-335Ti

Liên hệ

Thông tin sản phẩm hướng dẫn đặt hàng & vận chuyển

Overview

High speed vibration, 22,000 cycle per second (22 kHz) assists smooth cutting with less pressure force. Main compartment and other items are installed in Aluminum carrying case. Easy to carry and store. Foot switch is convenient for both hands free. It also saves power.

About ultrasonic cutter

Blade of ultrasonic cutter is vibrated in ultrasonic frequency by internal ceramics transducer. The microscopic and high-speed motion of the blade has strong effect and blade moves much smoother with light force. Tough material that require strong force to cut becomes unbelievably smooth.

<< note >>
* It does not reinforce the hardness of blades. The blade cannot cut the material that is harder than itself.
* Ultrasonic horn and ceramics heats up by long time use (about 10 minutes).
Protection circuit will stop the operation. Please rest the unit until it cools down.
* Pressure force to the blade is up to 3 kg. Too much pressure cause dislocation of blade, overheat or malfunction.
* Thermo protection may work shorter time.
When the unit stops operation with too much heat, please wait until it cools down.
* Please wear protection goggles, safety gloves for your safety while in use or replacing blades.
* Please be aware for the harmful fume generated from the material during the operation.
Please have good ventilation for such cases.

Applicable material and thickness (reference)

Resin: ABS, PP, PET, acrylic
Thickness: 3 mm maximum

　The cutting experience described above may vary by the environment and hardness of the material. For the material not listed above, please contact us, before you try.

Maintenance note

Blade and blade fixture must be fixed tight. WHen it becomes loose, the ultrasonic energy is not transferred to the blade.
* Tightening confirmation before use would be recommended.

Stains left on the blade and blade fixture can be a cause of overheat, irregular noise or malfunction.
* Please confirm the blade and the fixture before use and clean if necessary.

Protection circuit

Protection circuit may work and operation stops when the unit senses excess heat. Please wait until the unit, blade or any other parts cool down. After every part cooled down enough not to harm you, please confirm the fixture of the blade and stains around the blade. Please make sure blade is firmly fixed in its correct position, before use it again.

Về trang trước

Gửi emmail In trang